Mechanical Engineer - #1161041

Role Overview

• Own end-to-end mechanical engineering - covering design, documentation, vendor coordination, and site installation/start-up support.

Key Responsibilities

• Basic and detailed design of plant layout, pipe and fittings, pipe supports, piping isonetrics, material selection, equipment skid.

• Prepare and check mechanical static and rotating equipment datasheets for RFQs; evaluate vendor proposals for complaince with technical specs, codes, and regulations; lead technical clarifications.

• Liaise with OEMs/Vendors to validate technologies and recommend best-fit solutions based on performance, compliance, schedule, and total cost of ownership; drive technical clarifications and value engineering.

• Prepare documentation for submission and supporting project team, such as equipment data sheets and drawings, and As Built drawings for submittal to client.

• Compile/author ITP/IP and IOM manuals; interface with multidisciplinary teams (C&S, Process, ICA, controls) and construction/site teams.

• Produce/peer-review submission documentation; support project FAT/SAT, plant start-up, performance testing, and handover.

• Other duties as assigned from time to time

Job requirements

• Degree in Mechanical Engineering or equivalent from an internationally recognized university.

• Proficiency in project desgin software such as AutoCAD, Revit, Naviswork, Staad-Pro, Advance Steel will be advantageous.

• Familiar with relevant international standards/codes and onshore/offshore practices.

• Minimum 3 years work experience, preferably in the water/wastewater industry, with good knowledge in mechanical design for static and rotating equipment.