Engineer - #1129957

Responsibilities:

• Support global NPI (New Product Introduction) on product design and development.

• Prepare drawing proposal and tooling design.

• Conduct tooling buy-off and hands-on tooling setup.

• Initiate and conduct the improvement project evaluation.

• Liaise with customer on design requirement and alignment.

• Liaise with factory on capability compliance.

• Responsible on tooling expenses and cost control.

• Overseas travelling may be required.

Requirements:

• Min. Diploma in Mechanical/ Manufacturing/ Precision Engineering.

• Proficient in using Solidworks software.

• Preferably with working knowledge and experience in taping machine, laser mark, jig & fixtures design.

• Positive attitude and self-motivated.